Breadboard jumper cable
Cut the piece of wire 10cm long.
Remove the 3cm of plastic/Rubber insulation.
Get some piece of steel wires 10mm long.You can use remaining wire parts of the Resistors,Capacitors,Transistors,LED..etc.. for this.In this I used Resistor wire parts, because it's easy to handle.
Solder the cable center of the steel wire.
Cut the 10mm long Heat shrink tube pieces.In this I used ΙΈ1.0 heat shrink tubes.
Finally....! :)
PIC16F84A Controlled 230 Volt lights
Test the schematic and program using proteus
Parts we use to build it.
Subscribe to:
Posts (Atom)